
Afi-lite User Manual P/N 9040310
16
Automatic Cluster Removal (ACR) Parameters
The Afi-lite milk meter detects when the milk flow rate from the cow has slowed
enough to stop milking, then it removes the cluster.
ACR Parameters
Four parameters are involved in determining when the cluster is removed , ,
and .
determines the minimum amount of time the cluster is attached. This
parameter is also referred to as the “first delay”. The value of is
multiplied by 10. The resulting value is the minimum number of seconds the
cluster is attached. If the value is 18, then 180 seconds (three minutes) is the
minimum attachment time. If you want to
reduce the minimum attachment time to two and
a half minutes (150 seconds), change the value to
15.
Parameter helps prevent premature cluster
removals from cows with a slower milk let-
down.
determines the milk flow rate at which milking
will stop. When the flow rate of milk from the
cow decreases, the milk meter body is emptied at
greater intervals. When the milk meter body is
not emptied within the time specified in , the cluster is removed.
Milk flow rate is calculated as follows:
(Near the end of milking, 200 – 220 grams (0.2 kg = 0.44 lb [6.5 oz.]) of milk are released
each time the milk valve is opened. [The amount is measured.] 210 grams (6.7 oz) is used
in the calculations below.)
In this example,
= 30 seconds.
Therefore, if has a value of 30,
milking is stopped when the milk flow
rate drops to 0.42 kilograms (13.2 oz.) per
minute.
controls the delay between the vacuum
shut-off and cluster removal (usually
one second).
is the maximum cluster-on time, in
units of ½ minutes. (For example, a value of 14 is a maximum cluster-on time of
7 minutes. The time value of must be greater than the time value of . )
Milk Flow Rate
=
0.42 kilograms (13.2 oz.) per minute
Milk Flow Rate
=
X
0.21 kilograms (6.7 oz.) per minute
60 seconds
30 seconds
Milk Flow Rate
=
X
0.21 kilograms (6.7 oz.) per minute
60 seconds
value of
(30 seconds)
MILK FLOW RATE
mount of milk
Time
this page updated: July 27, 2003
Komentáře k této Příručce